download
Remove the following components to prepare for installation. There will be some differences between models and years. Remove both seats. Remove both left and right side fairing panels. Remove the bolt at the right rear of the fuel tank (if needed) to run the display cable to the left side of the frame (inboard of the air intake tube) along the factory wiring harness. Disconnect the negative battery cable (and any additional ground wires) at the battery. Remove the air intake tube from the air box. 3. Install the wiring. NOTE: The # indicates the connection to the unplugged 16 pin terminal strip. See the table. The Junction Board will be mounted on top of the air box just in front of the air temperature sensor. PHOTO1 An alternate position is shown in PHOTO 1A. The clear sleeve for the board gets stiff when it is cold. Warming makes it more pliable. If it is difficult to get the air sensor connector back on then use the alternate position on the left. The wiring enters the upper left corner for either position
BMW R1100RT FUEL Plus kit INSTALLATION Manual
↧
↧
Trending Articles
More Pages to Explore .....